Features
This board has a DA feature that produces an analog output (8ch voltage) controlled by the output indication value from the control CPU. It has a user-defined waveform output feature that produces an analog output of the indication values (4ch voltage) on in its memory, with a timing given by the internal/external timing signal. It also has a resistance simulator feature that can be used for an application that outputs a voltage signal corresponding a sensor with a variable resistance value, such as a thermistor.
- User-defined waveform output feature:: Outputs a waveform pattern that was registered in the user file with a set timing.
- Resistance simulator feature: Simulates voltage drop by the resistance. (Injection current must be is less than 5 mA).
Specifications
|
Output specification |
Single-end voltage output |
|
DA feature |
8ch4 selections for number of output channels: 1ch, 2ch, 4ch, or 8ch |
|
User-defined waveform feature |
4chUser defined waveforms are fixed on 1ch to 4ch
When user-defined waveform output is selected, the 5th through 8th channels remain available to the DA feature. The user defined waveform feature can be selected in software. |
|
Resolution |
12bit |
|
Conversion speed |
10 µsec / ch (100 kHz) |
|
Conversion output feature DA feature User-defined waveform feature |
Outputs a voltage whose value is set by the output indication value from the control CPU.Outputs a voltage determined by the indication value in the memory with an (internal / external) timing.
The conversion output feature can be selected in software. |
|
Output range |
Unipolar output: 0 to 1 V, 0 to 5 V, 0 to 10 VBipolar output: 0 to ±1 V, 0 to ±5 V, 0 to ±10 V
The output range can be selected for each channel via software. |
|
Accuracy |
For each range: ±0.1% of full scale (23 ±5°C) |
|
Output current |
Output current: 5 mA, Input current: 20 mA |
|
Output impedance |
10 Ω or smaller |
|
Isolation |
Bus is isolated |
|
Internal timing clock (For user-defined waveform output) |
Channel: 1chPeriod: 100 kHz to 1 Hz, 1, 2, 4, 5, or 8 step setting |
|
External timing signal input (For user-defined waveform output) |
Input channel: 1chPeriod: to 100 kHz
Input type: DC 5 V to 24 V (voltage input) Synchronous timing: can be selected from rise or fall |
- The output timing of the DA feature is synchronous to the model operation cycle.
- The user-defined waveform output feature is synchronous to the internal timing signal or the external timing signal.
- When using the user-defined waveform output feature and assigning the other channels to the DA feature, the DA feature output is synchronous to the signal for the user-defined waveform output feature.

