l Overview l Specifications l Ordering Information l Documentation l

A 4×4 pixel, 4-side scalable array of 3mm SiPM sensors. The array is packaged in a low-profile ceramic carrier with epoxy over-fill, and a pin-grid array for I/O connections. The Array-4 is available with both B-Series (ArraySB-4) and M-Series (ArraySM-4) silicon sensors. It should be noted that the fast output is not accessible from these products.

The performance characteristics and specification of each pixel in the array are identical to the corresponding Micro product, from either the B-Series or M-Series range of sensors.

The ArraySB-4 is sensitive to visible light in the range of 300nm to 800nm, with a peak PDE of 40% at 420nm. The pixel-level performance is as for the MicroSB-30035 in the B-Series Micro datasheet.

The ArraySM-4 is sensitive to visible light in the range of 400nm to 1000nm, with a peak PDE of 20% at 500nm. The pixel-level performance is as for the MicroSM-30035 in the M-Series Micro datasheet.

ArraySL-4:  Scalable silicon photomultiplier array for large area detection

Technical Highlights

  • Form Factor – unique low profile, ceramic package with minimal deadspace on all four sides to allow tiling
  • Pixel Array Fill Factor – 200μm deadspace between pixels
  • Uniformity – Superior uniformity compared to a PMT
  • Flexible – The Array-4 design is compatible with both pixellated and summed readout and can be configured with single ended, differential and X-Y differential preamplification electronics.
  • Magnetic Free Package Design – Magnetic free materials used in package. Ni free processing and Cu pin Alumina ceramic package not visible to MRI systems at 1.5 and 3 Tesla. (NOTE -CER version only)
  • External Cooling – Package has been designed so that an external TEC controller can be placed under the package for moderate cooling applications, i.e. reduced temperature operation (5-10°C) and/or temperature stabilization.
  • Interface Connections – Pin compatible package design with standard test sockets available on market today.
  • The Array-4 can be ordered with the option of a 16-channel preamplifier board that provides differential voltage outputs for each of the pixels in the array. It also incorporates a regulator that takes a nominal input voltage and steps it down to provide the optimal bias voltage for the array.
  • An additional option available for the Array-4 is the evaluation board. It connects to the preamplifier described above via the 80-way board-to-board connector then makes the output signals available via SMA connectors for fast and easy evaluation, e.g. via oscilloscope
  • 20-pin straight terminal SMT socket also available as an optional extra for allowing easy connection to test PCBs.